e+s Linear Shoring Double Slide Rail System / Osto
Module length::
4,25
trench shoring wall height::
4,64
accessories::
fasteners for outside beams of installation window, sheet piles KD 6/8 L=5,00 m for both-sided head shoring
rails lenght:
5,13
strut carts::
U-type H=2,0m
Suitable for concrete poured in situ, linear shoring can be adapted flexibly to suit project requirements and leaves the soil outside the trench largely unaffected, with no adverse impact on buildings and traffic flow. The use of overlapping linear shoring is also a benefit when operating at greater depths.
The inner and outer panels are held in vertically installed rails so that they can slide past each other. Since the extraction forces are much lower than on most other shoring systems, this improves the overall economy of the system, particularly in deeper trenches. Rigid boogie cars, height-adjustable to suit the increasing depth of the excavation, keep the beams and shoring panels at a uniform distance apart, and the trench width stays the same at all stages of the project. This noticeably improves the efficiency, speed, quality and cost-effectiveness of the process, with a key benefit of the system being contributed by the design of the beam, i.e. only with linear shoring is it possible to pivot the shoring panels in from the side.
Basic data
- Module length: 2.25 m – 6.50 m
- Length slide rail: 5.13 m – 9.13 m
- Panel height: 1.32 m / 2.32 m
- Pipe culvert height: variable
- Trench width: variable
Once the user has seen at least one product this snippet will be visible.